Filters
Accessories
Brand
Capacity
Component
Level
Model
Part Type
Parts Category
Sensored
Type
Voltage
ALL TRAXXAS
TRA5221 CRANKSHAFT MUTI SHAFT
TRAXXAS
Crankshaft, multi-shaft (for engines w/ starter) (with 5x15mm & 5x25mm inserts for short and standard crank lengths) (TRX 2.5, 2.5R, 3.3)
TRA5194X MAXX REVERSING UPGRADE MOD
TRAXXAS
Traxxas 5194X Reverse Upgrade Kit SportMaxx This is the optional Sportmaxx Reverse Upgrade Kit from Traxxas.This will mount into the transmission a...
View full detailsTRA5192X 2-SPD UPGRADE SPORTMAXX (right side of C)
TRAXXAS
TRA5192X 2-SPD UPGRADE SPORTMAXX (right side of C)
TRA5162 Drive Cup/Screw Pin M4/15
TRAXXAS
Traxxas Drive Cup/Screw Pin M4/15 Features: Metal construction, red and silver in color Steel CV center driveshaft Includes: One sleeve One M4/1...
View full detailsTRA4891 REAR HUB 2nd
TRAXXAS
This is a 2WD Gear Hub and Snap Ring for the Traxxas Nitro 4-Tec. COMMENTS: There are two spur gear pins molded into the gear hub. pjm 2/12/03 ir/jxs
TRA4841 TIE RODS/UPPER CAMBER RODS(REAR)
TRAXXAS
Traxxas tie-rods and upper camber rods are constructed of steel. Includes: Four Turnbuckles Two Draglinks. These turnbuckles are used on the steeri...
View full detailsTRA4827 BEARING BLOCK
TRAXXAS
Bearing block, front (supports front shaft)/belt tension adjustment shims (front/ middle)/ screws
TRA4825 STIFFNERS, CHASSIS
TRAXXAS
FEATURES: Black nylon construction INCLUDES: One left chassis stiffener One right chassis stiffener REQUIRES: Installation onto vehicle. SPECS: Lef...
View full detailsTRA4800 4 TEC PRO 15 TO 2.5 CONVERSION
TRAXXAS
Traxxas Pro .15 to TRX 2.5 engine conversion has a tune Pipe, bellcrank, & Throttle Servo Horn made of plastic. Linkage wire made of steel. Spe...
View full detailsTRA4372 CHROME WHEELS
TRAXXAS
Traxxas 4372 Wheel Chrome Nitro 4-Tec (2) These are the Replacement Chrome Wheels for the Electric Traxxas 4-Tec.Features: Nylon Construction Chro...
View full detailsTRA4329 Lwr Front Susp Mount 0 Deg
TRAXXAS
FEATURES: Nylon reinforced plastic construction 0° of casterINCLUDES: -One Front Lower Suspenson MountCOMMENTS: This part mounts to the chassis and...
View full detailsTRA4252 Stub axle carriers
TRAXXAS
This is a set of replacement Traxxas Rear Stub Axle Carriers, and are intended for use with the Traxxas Nitro Rustler, and Street Sport vehicles.
TRA4077 Starter Shaft
TRAXXAS
Starter shaft Replacement part for these models: TRX® Pro .15 Accessory part for these models: TRX® Pro .15 Marine
TRA4074 Backplate Recoil Engines
TRAXXAS
Backplate (for recoil start engines) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
TRA4050 Hi Speed Needle Assem
TRAXXAS
High-speed needle valve & seat assembly (w/ securing nut) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
TRA4048 Low Speed Spray Bar
TRAXXAS
Low-speed spray bar Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
TRA4041 Idle Mixture Needle Screw
TRAXXAS
Needle screw, idle mixture Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
TRA4039 Carb Attachment Stud Nut
TRAXXAS
Stud & nut, carburetor attachment Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
TRA4029 Head Gaskets TRX.15
TRAXXAS
Gaskets, head (aluminum) (2) Replacement part for these models: TRX® Pro .15
TRA4028 Brake support bracket/ brake band/ 3x25mm roundhead machine screw (1)/ 3x16mm cap hex screw
TRAXXAS
Brake support bracket/ brake band/ 3x25mm roundhead machine screw (1)/ 3x16mm cap hex screw Replacement part for these models: TRX® Pro .15 Marine
TRA4026 Wrist pin/ G-spring retainer (wrist pin keeper) (1)
TRAXXAS
4026 - Wrist pin/ G-spring retainer (wrist pin keeper) (1)
TRA3996 IDLER GEAR 20T 2
TRAXXAS
These are the Replacement 20 Tooth Idler Gears for the Traxxas E-Maxx Truck.These gears are located in the gearbox.FEATURES:Plastic constructionINC...
View full detailsTRA3990 Motor plate E-Maxx
TRAXXAS
This is the Replacement Motor Plate for the Traxxas E-Maxx Truck.This part holds the motors onto the truck.FEATURES:Blue anodizedAluminum construct...
View full detailsTRA3162 Countersunk Screws,3X24mm (6) (back wall)
TRAXXAS
Countersunk Screws,3X24mm (6) (back wall)
TRA3120X Xtra Tuff 20t Clutch Bell
TRAXXAS
Clutch bell, hardened steel (20-tooth) (32-pitch) (N. Hawk/Buggy/Street) ¶ÿ Accessory part for these models: TRX Pro .15